Crane parts of the bearing detailing

In the Wall-traveling Jib Crane or the gear unit is in the wheel bearing housing, if the inner race of the bearing and the radial direction of the radial thrust bearing is a fixed position of the shaft, so in these shafts when the shaft is rotated, the device an outer race means are fixed on the bearing bore, which is fixed on the bearing means of the bearing sleeve inside, also according to the type and manner of installation of the bearing means, so that both is used according to the demand determined.
Lifting accessories bearing device fixed to determine the way in time, but also need to take into account the purpose and structure of the organization, as well as transmission equipment type, between the bearing type of bearing, the force of nature, the use of the size and direction of the device distance, bearing on the device as well as the general arrangement and certain conditions of use.

Cantilever crane (LX-A electric single girder overhead crane http://www.cn-cranes.com/html/xbd/33.html) using the "Job Status switch" position, we must ensure that hanging with the use of consistent with the arm in the form of a job, or it may cause damage to the crane or accident. Because of different models, the above will vary, according to some automatic overload prevention device Instructions executed. After the operation, the cantilever Electric wire rope hoist boom sections should be fully retracted and placed on the front of the boom stand, hang hook.
  Bearings are single girder crane very important accessory, lifting accessories bearing fixed at the time of installation and there are many considerations to be primarily a crane after the bearing type selected for each axis and determine the size of the bearing on the shaft must be selected or the bearing bore on ways and means fixing method, the method is also very important.